Fujitsu AJYA54LALH - Page 16

En-15
Turn on the power of the outdoor unit and enter standby mode. (1)
When system is normal•
POWER/MODE lamp lights up. (ERROR lamp is off.)
POWER/MODE lamp:
ON
ERROR lamp: OFF
SELECT button
ENTER button
MODE/EXIT button
POWER
LED105 LED104
ERROR
MODE
LED101
(GREEN)
MODE
/EXIT
SELECT ENTER
SW107
SW108 SW109
LED102
(RED)
7 segment display:
turn off
When system is abnormal•
Check the settings as there is an error in the settings for outdoor unit address
(DIP switch SET3-1, 2) or number of connected slave units (DIP switch SET3-3, 4).
POWER/MODE lamp:
ON
7 segment display:
“-” display
ERROR lamp:
Blinking
POWER
LED105 LED104
ERROR
MODE
LED101
(GREEN)
MODE
/EXIT
SELECT ENTER
SW107 SW108 SW109
LED102
(RED)
Setting method(2)
MODE/EXIT
SELECT
ENTER
MODE/EXIT
SELECT
ENTER
ENTER
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
MODE/EXIT
ENTER
SELECT
SELECT
ENTER
ENTER
ENTER
MODE/EXIT
MODE/EXIT
: Press the “ENTER” button for more than 3 seconds.
1: Function Setting
First 2 digits Last 2 digits
7 segment display
(LED105, LED104)
(Flashing)
(When [F3] to [F9] are displayed, continue
to press the “SELECT” button until [F2] is
displayed.)
Use the “MODE/EXIT”, “SELECT”, and “ENTER” buttons to confi gure
settings according to the procedures below.
(If no setting is made, the factory default setting will be displayed.)
: Press the “MODE/EXIT” button.
: Press the “SELECT” button.
: Press the “ENTER” button.
2: Setting the
fi rst 2 digits
3: Setting the
last 2 digits
Every press of the “SELECT”
button will change the setting
number for the fi rst 2 digits.
(Continue to press the “SELECT” button until the
desired number appears at the last 2 digits.)
EXIT Press the “MODE/EXIT” button to cancel the setting mode.
Setting is complete when the lamp lights up
Press “ENTER” button to return to “2.Setting the fi rst 2 digits”
(If there is no operation for 5 seconds after the setting, the
display will return to “2: Setting the fi rst 2 digits”.)
(Continue to press the “SELECT” button
until the desired number appears at the
last 2 digits.)
Setting is complete when the lamp lights up
Press “ENTER” button to return to “2.Setting the fi rst 2 digits”
(If there is no operation for 5 seconds after the setting, the display
will return to “2: Setting the fi rst 2 digits”.)
9380545026-02_IM.indb 159380545026-02_IM.indb 15 19/08/2013 17:20:0819/08/2013 17:20:08