01-13
1. VERTICAL LOUVER CONTROL
Each time the button is pressed, the air direction range will change as follows:
Use the air direction adjustments within the ranges shown above.
The vertical airflow direction is set automatically as shown, in accordance with the type of operation
(Function Range)
( Fig. 10 : Vertical air direction range )
(Operation Range)
①,②,③,④ : During Cooling / Dry / Heating / Fan modes
selected.
Cooling / Dry / Fan mode : Horizontal flow ①
Heating mode : Downward flow ④
2. SWING OPERATION
When the swing signal is received from the remote controller, the vertical louver starts to swing.
The range of swing depends on the set airflow direction.
When the indoor fan is either at S-Lo or Stop mode, the swinging operation is interrupted
a
nd the louver stops at the memorized position.
( Stop mode means Operation stop.)
During AUTO mode operation, for the first minute after start-up, air-flow will be horizontal
; the air direction cannot be adjusted during this period.
The type of operation
Cooling / Heating / Dry / Fan mode
Range of swing
For Compact Cassette Type < AUU7/ 9/ 12/ 18RLF >
1
2
3
4
( Table 4 : Swinging range )
① to ④
To Next Page
Loading...
