Fujitsu ARYG72LHTA - Separation Method

03-22
3-5. SEPARATION METHOD
It is possible to install the indoor unit through narrow openings by separating the heat exchanger unit
and fan unit.
The separation method is as follows;
1. Remove parts (1) and (2).
(1) Control box cover
(2) Connection plates
2. Disconnect the wiers(3).
- Pipe thermistor wire
<For products with built-in drain pump>
3. Remove the screws (4).
4. Separate the heat exchanger unit and fan unit.
Heat exchanger
unit
Fan unit
Wire(s)
Slit
(2)
(1)
(3)
(4)
(2)
To attach the units again, reverse the instructions above.
Do not damage the wires.
-Drain pump wire
-Float SW wire