Fujitsu ARYG72LHTA - Page 93

03-06
Wierless remote controller (option)
Perform the “FUNCTION SETTING” according to the installation conditions using the remote controller.
CAUTION
•
•
in place.
This procedure changes to the function settings used to control the indoor unit according to
the installation conditions. Incorrect settings can cause the indoor unit to malfunction.
•
•
After the power is turned on, perform the “FUNCTION SETTING” according to the installation
conditions using the remote controller.
• The settings may be selected between the following two: Function Number or Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
• Refer to the installation manual enclosed with the remote controller when
the wired remote controller (option) is used.
Selecting the Function Number and Setting Value
(1)
While pressing the “ECONOMY” button and “TEMP.” (
) button simultaneously,
press the “RESET” button to enter the function setting mode.
(2) Press th e “10°C HEAT” button
Function number
Setting value
(3) Press the “TEMP.” (
/
/
) buttons to select the function number. (Press the “10°C HEAT”
button to switch between the left and right digits.)
(4)
Press the “ECONOMY” button to proceed to setting value.
(Press the “ECONOMY” button again to return to the
function number selection.)
(5)
Press the “TEMP.” ( ) buttons to select the setting
value. (Press the “10°C HEAT” button to switch between
the left and right digits.)
Please confirm the beeping sound.
(6) Press the “MODE” button once to send the function setting
information. Please confirm the beeping sound.
(7) Next, please press “Start/Stop(
(8) Press the “RESET” button to cancel the function setting mode.
)” button once to fix the function setting.
(9) After completing the FUNCTION SETTING, be sure to turn off the power and turn it on again.
CAUTION
• After turning off the power, wait 30 seconds or more before turning on
it again. The function setting does not become active unless the power
is turned off then on again.