EasyManua.ls Logo

Fujitsu ASBA09LGC - Page 14

Fujitsu ASBA09LGC
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
En-13
CLEANING AND CARE
3. Install the two Air lters and close the
Intake Grille.
Don't operate the air conditioner with being opened the
intake grille.
When air cleaning lters are used, the effect will increased by
setting the fan speed to “High”.
Replacing dirty Air cleaning lters
Replace lters with the following components (purchased sepa-
rately).
POLYPHENOL CATECHIN AIR CLEANING FILTER
: UTR-FA16
Negative air ions deodorizing lter: UTR-FA16-2
1. Open the Intake Grille and remove the Air
lters.
2. Remove the air cleaning lters attached to
the frames of the front panel.
Air lter
Air cleaning lter frame
3. Replace them by two new Air cleaning
lters.
1 Remove the old air cleaning lters in reverse order of their
installation.
2 Install in the same way as for installation of the air cleaning
lter set.
4. Install the two Air lters and close the
Intake Grille.
Don't operate the air conditioner with being opened the
intake grille.
3.
Replace the Air Filter and close the Intake Grille
.
1 Align the sides of the air lter with the panel, and push in
fully, making sure the two lower tabs are returned properly
to their holes in the panel.
Hooks(two places)
2 Close the Intake Grille.
(For purposes of example, the illustration shows the indoor unit
without Intake Grille installed.)
Dust can be cleaned from the air lter either with a vacuum
cleaner, or by washing the lter in a solution of neutral deter-
gent and warm water. If you wash the lter, be sure to allow
it to dry thoroughly in a shady place before reinstalling.
If dust is allowed to accumulate on the air lter, air ow will
be reduced, lowering operating ef ciency and increasing
noise.
During periods of normal use, the Air Filters should be cleaned
every two weeks.
Don't operate the air conditioner with being opened the intake
grille.
Air Cleaning Filter Installation
1. Open the Intake Grille and remove the Air
lters.
2. Attach the air cleaning lter to the frame
of the front panel.
Attach the lter on the inside of the tabs (6 places) so as
not to stick out.
Air cleaning lter frame
Tabs (6 places)
Tabs
(6 places)
Air lter
(In the above gure, the intake grille is omitted for the
explanation)
9317433044-05_OM.indb 139317433044-05_OM.indb 13 6/13/2013 2:39:56 PM6/13/2013 2:39:56 PM

Related product manuals