En-11
■
State of indicator lamps
Lighting pattern: Off, On, Blinking, Any state
State Causes and solutions
See
page
Automatic defrosting operation
⇒
Please wait until nishing the defrosting
(maximum of 15 minutes).
9
Filter indicator
⇒
Clean the air lter and reset the lter
sign.
8
Error code display
⇒
Consult authorized service personnel.
-
Timer setting error because of Auto restart
⇒
Reset the clock and timer settings.
-
Test run operation (for authorized
personnel only)
⇒
Press
to quit the test run.
-
Restricted function
-
(Slow)
(In multi connection) Standby mode
⇒
Check the set operation mode of the
indoor units.
9
■
Manual Auto operation and Filter indicator
reset
You can operate the air conditioner with on the
indoor unit.
Status Time to keep pressing Mode or operation
In operation More than 3 seconds Stop
Stopping 2 seconds or less Filter indicator reset
More than 3 seconds and
less than 10 seconds
Auto *
1)
More than 10 seconds
(Only for servicing.*
2)
)
Forced cooling
*1) In multi connection, the operation mode follows the other indoor
units.
*2) To stop the forced cooling, press this button or
on the remote
controller.
(3 times)
(Fast)
9387858020_OM.indb 11 2/8/2019 1:53:17 PM
To Previous Page
Loading...
