Fujitsu ASYG14KMCC User Manual


External heater output
Control Primary heater Auxiliary heater
Function setting
Indoor unit Wired R. C.
Control switching
external heaters
No. 61
Sensor activation*
2
Auxiliary heater
control 1
Heat pump
External device*
1
61-00 —
Auxiliary heater
control 2
Heat pump External device 61-01 —
Heat pump prohibition
control
External device None 61-02 On (Enabled)
Auxiliary heater
control by outdoor
temperature 1
Heat pump External device 61-03 On (Enabled)
Auxiliary heater
control by outdoor
temperature 2
Heat Pump External device 61-04 On (Enabled)
Auxiliary heater
control by outdoor
temperature 3
Heat Pump External device 61-05 On (Enabled)
Auxiliary heat pump
control
External device Heat pump 61-06 On (Enabled)
Auxiliary heat pump
control by outdoor
temperature 1
External device Heat pump 61-07 On (Enabled)
Auxiliary heat pump
control by outdoor
temperature 2
External device Heat pump 61-08 On (Enabled)
Auxiliary heat pump
control by outdoor
temperature 3
External device Heat pump 61-09 On (Enabled)
NOTES:
• After turning off the heater, 3 minutes of standby time is required by next power-on of the
heater.
• For items marked “—” in the table, any of validate or invalidate of the setting are acceptable.
• *1: External device means Hot water, Electrical heater, etc.
• *2: Sensor activation:
– Setting change from the factory setting is required.
– Indoor unit fan setting will be on for safety reason without sensor activation of wired remote
controller.
22
6)
Installation configuration of individual connection
External heating device is installed individually. (No use of indoor unit fan)
ON / OFF
Example of heating device:
- Floor heating device
- 232 -
12-5. Wall mounted type (KGTE, KGTF, KMTE, KMCE, KMCF, KETE, KETE-B, KETF, and
KETF-B)
12. External input and output
4-5 UNIT MULTI-SPLIT TYPE 4-5 UNIT MULTI-SPLIT TYPE

Fujitsu ASYG14KMCC Specifications

General

Brand	Fujitsu
Model	ASYG14KMCC
Category	Air Conditioner
Language	English