Fujitsu AUXG14KVLA - Page 322

7. Press the
/
button once to transmit the function setting information. 1 short beep will be emit-
ted from the indoor unit or the IR receiver when the signal is received correctly. If wrong code is
set, no beep sound will be emitted.
1 short beep
NOTE:
Press
/
button within 30 seconds after pressing MODE button.
For the function details, refer to Chapter 15-6. "Function details" on page 335.
8. Exit the function setting mode by pressing the RESET button.
RESET
- 314 -
15-3. Indoor unit (setting by wireless remote controller)
15. Function settings
4-5 UNIT MULTI-SPLIT TYPE 4-5 UNIT MULTI-SPLIT TYPE