M3093GX\DG\M3096G\GX\M3097G+\DG
Fi-4340C\Fi-4530C\Fi-4640S\M4097D\Fi-4750C\L\Fi-5750 SCSI
Win95\98\ME Installation Procedure
Rev052104A
Step A: Required hardware.
To install these models you will need a Narrow SCSI 50-pin controller and six foot (maximum)
Narrow SCSI cable.
Step B: Removing the shipping bracket.
It is recommended that before you connect the scanner to your computer that you inspect the
scanner and remove the shipping bracket first.
Removing the shipping bracket
: The flatbed scanner models typically come with a
factory installed shipping lock designed to protect the scanner during shipment. Before
the scanner can be used the shipping lock must be unlocked. Follow these instructions
to unlock the shipping bracket:
1. Slide the scanner to its side as shown in figure below.
2. Unscrew the retainer screw and remove the shipping bracket.
3. Place the shipping bracket in the “use position” slot and secure it with the retainer
screw (see figure below)
4. Place scanner back in its normal position
To Next Page
Need help?
General
