Fujitsu SCENICVIEW XP70 - Data Cable Connection

Downloaded from Projector.com
SCENICVIEW XP70
8 - English A26361-K954-Z100-1-5E19, edition 5
1
2
3
4
1 = Audio input (Audio in)
2 = S-Video input (S-Video)
3 = Video input (Video)
4 = Computer input (M1-DA)
► Be sure that the projector and the computer are switched off.
!
The computer power plug must be pulled out!
Connecting the data cable
i
Select the suitable data cable for your computer.
Analog: data cable DVI-VGA (M1-A with USB)
Digital: data cable DVI-DVI (M1-D with USB)
1
2
3
1 = Data connector for connection to computer
2 = Data connector for connection to projector
3 = USB connector
► Connect the connector (1) of the data cable to the active monitor port on the computer and
secure the plug-in connection by tightening the safety screws.
i
If your computer has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is usually active.
► Connect the plug (1) of the data cable to the M1-DA connector (4) at the back of the projector.