Preparing your notebook for use
Switching the notebook on for the first time
Switchingonforthefirsttime
We recommend tha t the notebook is supplied with power through
the mains adapter during this procedure.
When you switch your notebook on for the first time, the supplied software
is installed and configure d. Because this installation procedure m ust not be
interrupted, you should set aside enough time for it to be fully completed and
connect the notebook to the mains outlet using the mains adapter.
During installation, the notebook must only be rebooted wh en you are requested to do so!
You will be prompted to create a backup copy of the pre-installed operating system. This
backup copy can be used later to restore your notebook to its delivery configuration.
You can find information on how to restore the operating system, drivers, manuals
and special software in the Recovery Process manual.
Your operating system is pre-installed on the hard disk to help you when you
start using your note book for the first time.
1
► Switch the notebook on (1).
► During installation, f ollow the on-screen instructions.
Consult the operating system manual if anything is unclear about the requested input data.
If a Windows operating system is installed on your notebook, you will find a dditional
information on the system and drivers, help p rogrammes, updates, manuals etc. on
your notebook or on the Internet at "www.fujitsu-siemens.com/support".
10600969176, edition 1 English - 5
To Next Page
Loading...
