3. Installing the remote controller:
• When attaching to switch box:
a. Seal the wiring hole of the remote controller cable.
b. Put a remote controller cable through the hole of the rear case.
c. Fix the rear case by securing with attached screws (2 places).
Putty
Seal the wiring hole of the remote
controller cable with putty.
Remote controller cable
Trap
Screws
Box
Trap
Rear case
•
When attaching to the wall directly:
a. Seal the wiring hole of the remote controller cable.
b. Put a remote controller cable through the back hole of the rear case of the main
body.
c. Fix the rear case by securing if with attached screws (2 places).
Screws
Wall
Trap
Trap
Putty
Rear case
Seal the wiring hole of the remote
controller cable with putty.
• When routing the cable on the wall:
a. Cut off the cable guide of the front case with using a knife or a nipper.
b. Deburr the edge of the cable guide.
c. Fix the rear case by securing it with attached screws (2 places).
Epoxy putty
Remote controller cable
Screws
Rear case
- 13 -
ZONE CONTROL
SYSTEM
To Next Page
Loading...
