4
Congratulations on purchasing a Full Boar Drywall Sander
Kit. Your Full Boar Drywall Sander Kit FBDWS-75225 will
make quick work of sanding plasterboards to achieve a
smooth finish, ready for painting.
Read and understand the Owner’s Manual before operating
the Drywall Sander. Failure to do so could result in personal
injury or equipment damage.
INTRODUCTION
Read the whole manual carefully and make sure you know how to switch the tool off in an
emergency, before operating the tool. Save these instructions and other documents supplied
with this tool for future reference. The manufacturer cannot accept any liability for damage or
accidents which arise due to a failure to follow these instructions and the safety information.
This product has been designed for 230V and 240V only. Always check that the power supply
corresponds to the voltage on the rating plate.
Note: The supply of 230V and 240V is interchangeable for Australia and New Zealand.
This tool is double insulated, therefore no earth wire is required.
The power supply for this product should be protected by a residual current device (rated at
30mA or less). A residual current device reduces the risk of electric shock.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord
available through the service organization.
Note: Double insulation does not take the place of normal safety precautions when operating
this tool. The insulation system is for added protection against injury resulting from a possible
electrical insulation failure
within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool. Before use,
inspect the extension lead for signs of damage, wear and ageing. Replace the extension lead if
damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of an extension
lead not suitable for the power input of the tool or which is damaged or defective may result in a
risk of fire and electric shock.
ELECTRICAL SAFETY
WARNING! When using mains-powered tools, basic safety precautions,
including the following, should always be followed to reduce risk of fire, electric
shock, personal injury and material damage.
WARNING! Damaged or overloaded extension cords could overheat, arc, and
burn, resulting in death or serious injury.
To Next Page
Loading...