LOG TABLE (Sold Separately)
A log table/platform can be mounted on the log cradle
directly.
LOG LIFT TABLE ATTACHMENT (Sold Separately)
The log lift table attachment can be mounted on the beam.
Easily lift the log from the ground to a position flush with
the beam.
ENGINE ON/OFF SWITCH
The engine switch has two positions. OFF - engine will not
start or run. ON - engine will start and run.
RECOIL STARTER HANDLE
The handle is used to start the engine.
FUEL SHUT-OFF VALVE
The fuel shut – off has two position. CLOSED ( ) - use this
position to service, transport, or store the unit.
OPEN ( ) - use this position to run the unit.
CHOKE CONTROL
The choke control is used to choke the carburetor and assist
in starting the engine. The choke control slides between the
CHOKE CLOSED and CHOKE OPEN positions.
THROTTLE CONTROL
The throttle control regulates the speed of the engine and will
shut off the engine when it is moved to the STOP position.
The throttle control moves between FAST , SLOW ,
and STOP positions.
SPLIT CONTROL HANDLE
The control handle is used to move the wedge up and
down to split logs. The control handle has three positions:
Forward, Neutral, and Reverse. See the “operation” section
for instruction.
MANUAL TUBE
Keep manuals safely in the tube.
BEAM LOCK BRACKET
The beam lock bracket is used to secure the beam in the
horizontal position.
LIFTING HANDLE
The lifting handle is included for easy transition from
horizontal to vertical.
2” BALL HITCH COUPLER
The coupler hitch is at the end of the tow bar and attaches to
a tow ball for transportation purposes.
LOG STRIPPER
The log stripper is designed to remove any partially split
wood from the wedge. This may occur while splitting large
diameter wood or freshly cut wood.
BEAM ASSEMBLY
The U-beam structural design is signicantly stronger than a
typical I-beam design.
Engine On/Off Switch
Recoil Starter Handle
Choke Control
Fuel Shut-Off Valve
Throttle Control
27
|
Know Your Machine
To Next Page
Loading...
