72 mm
Dimension of the clipping
for setting of the instrument
in panel
29 mm
PROTECTIVE VINYL:
This adhesive vinyl (included inside the packing) protects the instruments against
water drippings, as in commercial refrigerators, for example. Do the application after
finishing the electrical connections.
Remove the protective paper
and apply the vinyl on the
entire superior part of the
device, folding the flaps as
indicated by the arrows.
ENVIRONMENTAL INFORMATION
Package:
The packages material are 100% recyclable. Just dispose it through specialized
recyclers.
Products:
The electro components of Full Gauge Controls controllers can be recycled or reused if it
is disassembled for specialized companies.
Disposal:
Do not burn or throw in domestic garbage the controllers which have reached the end-of-
life. Observe the respectively law in your region concerning the environmental
responsible manner of dispose its devices. In case of any doubts, contact Full Gauge
Controls for assistance.
IMPORTANT
According to the chapters of norm IEC 60364:
1: Install protector against overvoltage on the power supply.
2: Sensor cables and signal cables of the computer may be joined, but not in the same electric conduit
through which the electric input and the activation of the loads run.
3: Install transient suppressors (RC filters) parallel to the loads as to increase the product life of the
relays.
Contact suppressor connection diagram
Supressor
A1
A2
A1 and A2 are the
contactor coils
Diagram for suppressor installation for direct
drive load inputs
Load
Supressor
For direct activation the maximum
specified current should be taken
into consideration.
Note: The length of the sensor cable may be increased by the user up to 200 meters, using a PP 2 x 24
AWG cable. For immersion in water, use thermometric well.
All rights reserved
Suppressors on offer from Full Gauge Controls
2013
To Previous Page
Loading...
