Full Gauge MT-512Ri LOG - Functions with Facilitated Access; Maximum and Minimum Temperature Logs; Manual Datalogger Activation; Clearing Datalogger Memory

IMPORTANT
1:
2:
3:
According to the chapters of norm IEC60364:
Install on the power supply.
Sensor cables and signal cables of the computer may be joined, but not in the same electric conduit
through which the electric input and theactivation of the loads run.
Install transient suppresors (RC filters) parallel to the loads as to increase the product life of the
relays.
protector against overvoltage
For more information, please contact our Technical Support by e-mail: or by
phone +55 51 3475.3308.
support@fullgauge.com
Schematicfortheconnectionofsupresors
tocontactors
Suppresor
A1
A2
A1and A2arethe
contactorcoilterminals.
Schematicfortheconnectionofsupresorsto
directactivationloads
Load
Suppresor
Fordirectactivationthemaximum
specifiedcurrentshouldbetaken
intoconsideration.
PROTECTIVEVINYL:
This adhesive vinyl (included inside the packing) protects the instruments against
water drippings, as in commercial refrigerators, forexample.
Do the application after finishing the electricalconnections.
Remove the protective paper
and apply the vinyl on the entire
superior part of the device,
folding the flaps as indicated by
the arrows.