Full Spectrum Laser FSL200 - Page 8

7
Thefanspeedshouldbesetaccordingtotheactualrequirementsto
removeallsmokewithoutcreatingtoomuchofavacuum.Duringlaser
cutting,thelasermachineshouldnotfillupwithsmoke.Ifthereis
lingeringsmokeduringcuttingincreasethefanspeed.Toohigha
settingmaycausetheworkpiecetoliftupandbepulledtowardthe
vacuumcreated.Inaddition,toohighafanspeed
increasesthepowerconsumptionaswellasthenoiselevel.

TimeSetButton
While the machine is running, press the Timer Set button, the digital           
display will show HXXX. Then press the Flow+/Flow buttons to adjust          
the shutdown timing. XXX represents the timer countdown in hours         
with a maximum of 300 hours and minimum of 1 hour. After you are             
satisfied with the setting, press the Timer Set button again and the           
digital display will show HXXX and start the countdown timer. For          
example, H005 represents that the machine will shut down        
automatically in 5 hours. This function is useful at the end of the day             
when you turn the laser off but still want to keep cleaning any smell             
residuesthatmayremaininsidethemachine.

Ok/SettingButton
If the machine is in alarm status and buzzer sounds, press the           
Ok/Setting button to turn OFF the alarm. If the machine is not in alarm             
status, press the Confirm/Set button to check the total working hours of           
themachine. 



 
FullSpectrumLaserFSL200UserManual,2016,Rev.A