12
Please check each item below if you have trouble with your vacuum�
Unplug the vacuum from the power supply before servicing�
Problem Check Point Possible Solution
Suction power is weak. • Vacuum bag • If vacuum bag is full, replace it.
• Wand or hose • If clogged or blocked,
remove the object�
The vacuum does not work. • Is the hose adapter inserted • Insert hose until it snaps
into the suction opening of into place�
the vacuum completely?
• When the vacuum bag is full • Turn the vacuum off and
or any of the accessories are unplug the vacuum�
blocked, the over-heating Check the vacuum
protection for the motor bag and accessories
is activated� and remove any
blockages� The vacuum
can be turned on again after
approximately 20 minutes�
Power cord does not rewind. • Power cord • Pull the power cord out a
little and press the cord
rewind button again�
Power cord won’t pull out of • Power cord • Do not pull it out by force.
the vacuum� Rewind it a little by
pressing the cord rewind
button and try pulling it
out again�
Troubleshooting Guide
For Best Performance
• Keep machine and all accessories clean and in good operating condition.
• Replace filters after using 6 to 12 vacuum bags or more frequently if vacuuming fine powders such as flour
or dry wall dust�
• Always use genuine filters and parts, as use of other products may result in poor cleaning or filtration
performance� Fuller Brush filtration products are designed for maximum performance�
• Store machine carefully in a dry area.
• For optimum cleaning performance and safety, follow your owner’s manual.
To Next Page
Loading...
