FULTON ModSync SE User Manual

Questions? Please Contact Your Local Manufacturer’s Representative
3-19
SECTION 3 ModSyncSE-User-Manual-211020 OPERATION
! WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the sta responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualied
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
 Password and Screen Saver
Password Conguration allows a 4-digit password to be entered that prevents
the unauthorized access to the setup screens. The Password Bypass Timer
allows access to the setup screens (once the password has been entered) for the
congured time. When the password bypass timer expires, the password will
need to be entered to access the setup screens. The Screen Saver conguration
allows for the screen saver to activate after the entered time. Touching the screen
brings the Main Menu back. See Figure 13.
 User Password: Displays the current user password and allows the user to
change the current user password. When the Password is enabled the only
accessible screens without entering the password are the System Status
Screen, Trend Screen, and Alarm Status Screen. To disable the password
enter 0 into the User Password setting.
 Bypass Timer: After the password has been entered the user will have
unlimited access to all screens until the bypass timer expires. Once the
bypass timer expires the password will need to be re-entered to access
protected screens.
 Default Settings: By selecting “Load” the ModSync® will load the factory
default settings.
 Save User Settings: By selecting “Save” the ModSync® will retain all user
settings in memory.
 Load User Settings: By selecting “Load” the ModSync® will load all user
settings saved previously.
 Screen Saver: When enabled the ModSync® will load a screen saver if
the screen has not been touched before the Dim Timer expires. Once the
screen saver has loaded just touch the screen again to load to the Main
Menu.
FIGURE 15 – DIGITAL OUTPUT HARDWARE CONFIGURATION SCREEN

FULTON ModSync SE Specifications

General

Brand	FULTON
Model	ModSync SE
Category	Controller
Language	English