© Fulton Group N.A., Inc. 2021
3-18
OPERATION ModSyncSE-User-Manual-211020 SECTION 3
! WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the sta responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualied
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations
Analog Outputs: All analog outputs need to be congured for the options
desired before the outputs will operate. Only options that have been
enabled will be selectable. All analog outputs are 4-20mA.
» Boiler # Pump VFD: Congures the output to control the boiler
circulator pump’s VFD. This selection will only be available if Boiler
Pumps are enabled and the VFD selection has been enabled.
» System Pump # VFD: Congures the output to control the System
Pump’s VFD. This selection will only be available if System Pump are
enabled and the VFD selection has been enabled.
FIGURE 14 – ANALOG OUTPUT HARDWARE CONFIGURATION SCREEN
To Next Page
Loading...
Need help?
General