This document is an instruction manual for the FunTime FT421CR Popcorn Machine, designed for AC 120V / 60Hz operation. It outlines the assembly, operation, cleaning, maintenance, and warranty information for the device.
Function Description
The FunTime FT421CR is a popcorn machine designed for household use, capable of popping kernels with oil and sugar to produce hot, buttered popcorn. It features a kettle for heating and stirring, a warming function to keep popcorn fresh, and a spot light.
Important Technical Specifications
- Model: FT421CR
- Power: AC 120V / 60Hz
- Kettle Capacity: Not explicitly stated, but oil capacity is Max 15g.
- Switches: Two function switches:
- (I) LIGHT: Controls the spot light and warmer.
- (II) POP: Controls the kettle heater and stirrer.
Usage Features
The popcorn machine is designed for ease of use with several features:
- Assembly: The manual provides detailed steps for assembling the kettle, block plate, detachable plastic door, and crumb tray.
- The kettle assembly involves screwing lips, an axle fixer, and a stirrer onto the gear box, then holding the kettle on the supporter and inserting pins through the kettle and supporter. Finally, an internal plug is inserted into a socket on the inner top.
- The kettle is placed on its supporter and connected to the socket.
- The block plate is placed on the filter.
- The detachable plastic door is inserted onto its hinge.
- The crumb tray is inserted into the opening at the bottom of the unit.
- Operation:
- Pre-operation checks: Ensure the unit is unplugged, voltage matches the rating label, and internal surfaces are clean.
- Kettle setup: Hook the kettle onto the hanger and plug in the power cord.
- Preheating: Switch on the light and warmer (I). Fill the kettle with a suitable amount of butter or oil (Max 15g). Preheat for 3-4 minutes until steam emerges.
- Popping: Open the lid (using an oven mitt as it may be hot) and pour in pre-mixed kernels and sugar. Switch ON the Kettle Heater & Stirrer (II) to begin stirring. Close the door. Popcorn typically starts popping after 2-3 minutes.
- Completion: Once popping is complete (no more popping sound), switch OFF the Kettle Heater & Stirrer (II). Rotate the roller bar to empty all remaining popcorn from the kettle.
- Warming: Keep only the spot light and warmer (I) ON to keep the popcorn warm, dry, and tasty.
- Serving: Use the provided popcorn scoop to serve.
- Continuous popping: Repeat steps 7-10 for subsequent batches.
- Safety Precautions:
- Read all instructions before use.
- Avoid touching hot surfaces; use handles/knobs.
- Do not immerse cord or plug in water/liquid.
- Supervise children closely.
- Unplug when not in use and before cleaning.
- Allow hot parts to cool before handling.
- Do not operate with damaged cord/plug or if malfunctioning.
- Only authorized technicians should open the unit for repairs.
- Do not use unapproved accessories.
- Do not pop kernels in a dry pot (without oil).
- Do not immerse the kettle in water.
- Kettle surface is HOT during and after use; do not touch.
- Unplug, clean, cover, and store in a dry, safe place when not in use for extended periods.
- Do not let the power cord hang over edges or touch hot surfaces.
- Do not place near hot gas/electric burners or in a heated oven.
- Exercise extreme caution when moving the appliance with hot oil/liquids.
- Turn all switches to "OFF" before unplugging.
- Not recommended for outdoor use.
- Use only for indicated purpose.
- Always add oil and kernels before operating to prevent overheating.
- Place the unit over a countertop when unloading popcorn to prevent burns from residual hot oil/water.
- Keep out of reach of children.
- Do not clean with abrasive materials.
- Never force parts or brackets.
- No parts are dishwasher safe.
Maintenance Features
The manual provides procedures for both quick and standard cleaning to ensure longevity and hygiene.
- Quick Cleaning Procedure (Recommended after 3-4 uses to prevent sugar buildup):
- Switch OFF both (I) and (II) switches.
- Pour 300-500 ml of water (no detergent) into the inner pot.
- Switch ON the kettle stirrer & heater (II) to boil the water and allow the stirrer to turn, helping to remove stuck sugar.
- Pour out the water after 1-2 minutes of boiling.
- Caution: The kettle will be HOT.
- Repeat 2-3 times for better results.
- Standard Cleaning Procedure:
- Perform the "Quick cleaning procedure" until the kettle is relatively clean.
- Switch off the machine and wait for the popping pot to cool down completely.
- Clean the inside and outside of the kettle using a brush and a wet towel.
- NEVER immerse the kettle into water.
- After using the popcorn machine, use a wet towel to clean the main unit, main body, and glasses.
- The rubbish tray should be cleaned frequently to prevent bacteria growth.
- Inspection on Arrival: Thoroughly inspect the unit upon receipt. Any damage must be reported immediately to the transportation company to initiate a claim, as failure to do so may affect warranty status.
- Limited Equipment Warranty:
- Duration: Five (5) year limited warranty on parts for workmanship and material in the United States and Canada, effective from the date of service.
- Coverage: Limited to repair or replacement of defective parts by a factory-authorized service agency. Portable models should be taken to the closest FunTime service agency, transportation prepaid.
- Exclusions: FunTime does not assume responsibility for loss of revenue. International shipments have separate warranty terms.
- Non-stick Coatings: One-year warranty under normal use and reasonable care. Does not cover damage from improper cleaning, maintenance, metallic utensils, abrasive cleaners, product identifiers, point-of-sale attachments, or other non-food objects in continuous contact with the coating.
- "Special Products": Six (6) months on parts and ninety (90) days on labor.
- Voiding Warranty: Warranty is void if the unit is disassembled or tampered with for purposes other than repair by an authorized service center. Also void if damage results from improper installation, misuse, wrong voltage/gas, or operation contrary to instructions.
- Parts Warranty (for out-of-warranty repairs): Ninety (90) days on parts only; labor to replace parts is not warranted.
- Parts Not Covered by 5-Year Warranty:
- 30-day limited warranty on consumable parts (kettles, light bulbs).
- Cosmetic damage (scratches, nicks, dents).
- Water damage to kettle components due to immersion or improper cleaning.
- Damage to kettle components due to improper use of cooking oil.
- Installation of equipment or damages from improper installation.
- Damages from abuse or misuse.
- Operation contrary to instructions.
- Cleaning of equipment.
- Seasoning of griddle plates.
- Voltage or gas conversions.
- Pilot light adjustment, miscellaneous adjustments, thermostat calibration, by-pass adjustment.
- Resetting circuit breakers, safety controls, or reset buttons.
- Replacement of bulbs or fuses.
- Damage created during transit, delivery, installation, or by acts of God.
- Extent of Warranty: The warranty is exclusive and in lieu of all other warranties (oral, written, implied, including merchantability or fitness for purpose). FunTime's liability is limited to the cost of furnishing a replacement for a defective part/assembly. This liability terminates upon warranty expiration. The "Original Purchaser" is defined as the individual, company, or organization stated in FunTime's warranty records or an authorized reseller. FunTime is not liable for incidental, special, indirect, or consequential damages resulting from product use, misuse, inability to use, or defects.
- Assistance: For operation or maintenance assistance, contact the Service Department via writing, phone, fax, or email, mentioning the model and serial number.
Need help?
General
To Next Page
