Need help?Do you have a question about the Furman PS-PRO and is the answer not in the manual?
General| Brand | Furman |
|---|---|
| Model | PS-PRO |
| Category | Recording Equipment |
| Language | English |
Explains the PS-PRO's role as a power sequencer for timed equipment power-up/down and its benefits.
Details the front panel key switch for local/remote control and low-voltage wiring.
Explains the timed delay sequence for powering outlets on and off and the delay adjustment.
Describes how to initiate ON/OFF sequences using the front panel key switch.
Details controlling the unit remotely using switches and optional LEDs.
Explains the difference between momentary and maintained switches for remote operation.
Describes settings and operation for maintained contact remote control.
Pushbutton switch for initiating ON/OFF sequences in Momentary Mode.
LED indicator for protection device integrity; goes out if compromised.
Shuts down power if input voltage is below 80V or above 140V.
Screwdriver-adjustable trimpot for setting total turn-on/turn-off delay time.
LEDs indicating power applied to each delay stage outlet.
Neon indicators to analyze AC mains wiring faults.
Details the 20-amp circuit breaker and how to reset it.
Describes the rear panel unswitched outlets for continuous power.
Details the three pairs of switched outlets labeled Delay 1, 2, and 3.
Allows connection of remote switches and optional LEDs.
PS-PRO remembers its last state (ON/OFF) until power is lost.
Compares front panel switch function with remote control in momentary mode.
Output terminal to indicate availability of power at PS-PRO outlets.
Indicates remote switch status or if the unit is under local control.
To Next Page
