4-4
Mounting the IB-581
Refer to the outline drawing at the back of this manual.
1. Fix the hanger by using five tapping screws (supplied with option kit).
237
79
82
Dimensions of hanger
2. Attach all connectors to the bottom of the terminal unit.
PRINTER
COM1
COM2
K-BOARD
24VDC
Printer
Keyboard
For 24 VDC
Not used.
Communication
unit
Terminal unit (IB-581), bottom view
3. Screw knobs to fix the terminal unit to the hanger.
4. Use the 17JE-573-10 to connect the NBDP port of the control unit and COM1 port of the
NBDP terminal unit.
Keyboard
1. Attach the labels for NBDP and the compass safe distance to the appropriate locations
shown below.
Label for key operation for
FUNCTION KEYS (supplied)
LABEL FOR COMPASS SAFE DISTANCE
(supplied)
2. Attach four fasteners (small, supplied with the optional kit) to the bottom of the keyboard.
3. Attach four fasteners (large, supplied with the optional kit) to the small fasteners used in
step 3.
4. Peel the paper from four fasteners.
5. Fix the keyboard to the mounting location.
To Next Page
Loading...
