APPENDIX 1 MENU TREE
AP-6
1
Files Screenshots
User Data
Units Units
Fuel
Formats and
References
Screenshots
(shows number of screenshots saved to internal memory)
Export File Format (C-MAP, GPX, CSV)
Routes/Points (Shows number of routes/points
saved to internal memory)
Routes and
Points
Export to SD
Tracks
Settings
Backup
Notifications
Log
Export to SD
Import from SD (select file to import)
Tracks/Track Points (Shows number of routes and
points saved to internal memory)
Export to SD
Export to SD
Export to SD (CSV)
Distance (NM, SM, km, NM+ft, NM+m, SM+ft)
Rate (l/h, US gal/h, UK gal/h)
Bearing Display (M, T)
Magnetic Variation (Internal, External)
True Wind Calculation Reference (Ground, Surface)
Position Format (DD°MM.MMMM’, DD°MM.MMM’, DD°MM.MM’,
DD°MM’SS.ss”, DD.DDDDDD)
Speed (kn, km/h, m/s, mph)
Wind Speed (kn, km/h, m/s, mph, Bft)
Depth (m, ft, fm, pb, HR)
Fish Size (cm, inch)
Air Pressure (hPa, mBar, mmHg, inchHg)
Oil/Boost Pressure (Bar, PSI, kPa)
Volume (l, US gal, UK gal)
Height/Length (m, ft)
Temperature (°C, °F)
Restore from SD (select file to import)
Import from SD (select file to import)
Initial
Setup
Vessel Type (Power Displacement, Power Planing, Sail Boat)
NAVpilot Control (ON, OFF)
GP330B SBAS Mode (ON, OFF)
WB200 SBAS Mode (ON, OFF)
SBAS Mode (ON, OFF)
Heading Offset (-180.0° to +180.0°, 0°)
Pitch Offset (-90.0° to +90.0°, 0°)
Roll Offset (-90.0° to +90.0°, 0°)
Max RPM (4000, 8000, 12000, 16000, 20000)
Max Oil Pressure (600 kPa, 800 kPa, 1000 kPa)
Max Engine Boost Pressure (160 kPa, 200 kPa, 320 kPa)
Max Engine Coolant Pressure (320 kPa, 520 kPa, 600 kPa)
Max Fuel Pressure (320 kPa, 520 kPa, 600 kPa)
Engine Temperature (86 to 302°F, 122 to 410°F)
Engine Oil Temperature (86 to 302°F, 122 to 410°F)
Transmission Temperature (86 to 302°F, 122 to 410°F)
Language (English US, English UK, others)
Vessel
Autopilot
Data
Acquisition
SC-30 Setup
Instruments
Range
Setup
SBAS Mode (ON, OFF)
Restart GPS
Dynamic Model (At Sea, Automotive)
Navigation Speed (Low, High)
Internal
GPS Setup
Position Filter (Off, Low, Medium, High)
Speed Filter (Off, Low, Medium, High)
Map Datum (WGS 1984, others)
Perspective Angle (5° to 60°, 30°)
Navigation
Setup
2
Restore
Defaults
Restore Default Settings (Select Yes/No from pop up window)
APPENDIX 1 MENU TREE
AP-7
Engines (1, 2, 3, 4)
Manual Management (ON, OFF)
Total Fuel Capacity (0 to 9999 US gal)
NMEA Output Instance (0, 1, 2, 3, 4, 5)
Select IF (Select [IF-NMEAFI] to set the analog data that is input
from the IF-NMEAFI.)
Category (Wind,ST800/ST850, Fuel, Fresh Water, Waste
Water, Live Weel, Oil, Black Water)
Resistance Full (0 ohm to 300 ohm; default: 33.50 ohm)
Resistance Mid (0 ohm to 300 ohm; default: 310.00 ohm)
Resistance Empty (0 ohm to 300 ohm; default: 240.00 ohm)
Capacity (0 to 2650 US gal)
Self Test (Starts a diagnotic test)
Refresh (Refresh the NMEA device list)
Software Version
Build Number
Released
Boot Version
Kernel Version
RootFS Version
Cartography
Chart 1
Serial Number
Program Version
Boot Version
FPGA Version
FPGA Program Version
About OSS
Copyright
PORT/STBD Reversing (ON, OFF)
System
Information
Fish Finder
Information
C-Weather Information
Engine Setup
About
Service (For technicians only, requires password)
Clear
Memory
Rudder
Setup
Manual Fuel
Management
IF NMEA
Setup
2
Restore
Defaults
Restore Default Settings (Select Yes/No from pop up window)
Restore All to Factory Defaults (Select Yes/No from pop up window)
Clear All Data and Settings (Select Yes/No from pop up window)
To Next Page
Loading...
