How to fix Furuno Plotter if it will not turn on?
If your Furuno Plotter isn't powering on, there are several things to inspect: * Verify the fuse hasn't blown. * Ensure the power connector is securely fastened. * Look for any corrosion on the power cable connector. * Inspect the power cable for damage. * Confirm the battery voltage is within the range of 10.8 to 31.2 V.
Why is my Furuno Plotter position not fixed?
If your Furuno Plotter isn't fixing your position, consider the following: * Make sure the antenna connector for the external antenna is tightly connected. * Check the GPS Status Display to see the number of satellites being received. * If using the internal GPS antenna, verify that the [Internal Antenna] setting at [Internal GPS Setup] on the [System] menu is set to [On].
What to do if no picture appears on Furuno Plotter?
If no picture is appearing on your Furuno Plotter, try the following: * Tap the Power key and use the slider bar in the [Backlight Brilliance] window to increase the brightness. * If the unit is hot, move it to a cooler location to allow it to cool down.
What to do if Furuno Plotter is not responding?
If your Furuno Plotter is unresponsive, try turning the power off and then on again. If the problem persists, the equipment may be defective, and you should contact your dealer for further assistance.
Why is the bearing wrong on my Furuno Plotter?
If the bearing is wrong on your Furuno Plotter, check the [Variation] setting at [Compass] on the [System] menu.
Why does Furuno Plotter show speed when stopped?
If the speed indication on your Furuno Plotter isn't zero after stopping the boat, check that the [Position Filter] setting at [GPS Position] is [On] within the [System] menu.
How to turn on track on Furuno Plotter?
If the track of your vessel is not being plotted on the Furuno Plotter, make sure the track is turned on. Go to [Menu] and tap [Track] to enable it.
General guidelines and important information for users of the manual.
Overview of physical controls, touch operations, and basic screen interactions.
How to enter, manage, search, and display points, routes, and tracks.
How to navigate to points and routes, and manage navigation functions.
How to start, stop, and manage the display of recorded boat tracks.
How to enter, edit, move, filter, and delete points.
How to create, rename, edit, and connect routes.
How to navigate to quick points, saved points, and routes.
Regular checks and maintenance procedures for optimal performance.
How to resolve common issues and troubleshoot the unit.
Detailed instructions for mounting the display and antenna units.
Diagrams and instructions for connecting power and signal cables.
To Next Page
General
