Particularly high room temperature - no
machine fault.
Lower the room temperature if possible.
1) In case of error message on the LCD (e.g. E51- only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the Start/Pause button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
MACHINE SETTINGS
Setting Implementation
BUZZER permanent off
1. Turn the programme selector to any programme.
2. Press simultaneously the Intensiv (Intensive) and Extra
Knitterschutz (Long anticrease) buttons and hold down for
approx. 5 seconds.
3. The buzzer is by default always off.
Water hardness
Water contains, a variable
quantity of limestone and min-
eral salts of which quantities
vary according to geographi-
cal locations thus varying its
conductivity values.
Relevant variations of the con-
ductivity of the water com-
pared to those prefixed by the
factory could slightly influence
the residual humidity of the
laundry at the end of the cy-
cle. Your dryer allows you to
regulate the sensitivity of the
drying sensor based on con-
ductivity values of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the Intensiv (Intensive) and START/
PAUSE buttons and hold down for approx. 5 seconds. Lights
show the current setting:
– Tank - low conductivity <300 micro S/cm
– Filter - medium conductivity 300-600 micro S/cm
– Condenser - high conductivity >600 micro S/cm
3. Press the START/PAUSE button sequentially until you set de-
sired level.
4. To memorize setting press simultaneously the the Intensiv
(Intensive) and START/PAUSE buttons or turn knob to OFF
position
TECHNICAL SPECIFICATIONS
height x width x depth 85 x 60 x 58 cm
drum volume 108 l
depth with the load door opened 109 cm
adjustable height 1.5 cm
the appliance weight 52 kg
maximum load volume
7 kg
voltage 230 V
necessary fuse 6 A
total power 1050 W
energy efficiency class A
energy consumption kWh/cycle
1)
1,85 kWh
55
To Next Page
Loading...
