FUTABA 16SZ - Page 119

120
＜ Linkagemenu ＞
Datareset
0RGHOPHPRU\VHWWLQJGDWDUHVHWE\LWHP
This function is designed to allow you to reset
selected portions or all of the settings saved in
the active model memory. You may individually
choose to reset the following sets of data:
Trim (All condition):
Reset the digital trim setting.
*All the conditions, or the condition currently being displayed
WKHHQWLUHJURXSIRUJURXSVHWWLQJFDQEHVHOHFWHG
*The trim step amount and trim rate are not reset.
Trim (Current and Group condition):
Reset the digital trim setting.
*Current condition, group condition, can be selected.
*The trim step amount and trim rate are not reset.
Data resetting method
7DSWRWKHLWHP\RXZDQWWRUHVHWDQGWDS
WKHVFUHHQ
$FRQ¿UPDWLRQPHVVDJHDSSHDUV
Model menu setting:
Resets all the functions in the Model menu
H[FHSWFRQGLWLRQVHOHFW
All model setting:
Resets all Linkage and Model menu functions
H[FHSWIRUIUHTXHQF\PRGHOVHOHFWDQGPRGHOW\SH
Function Name:
A function name is reset.
Telemetry:
Reset the telemetry setting.
 >7ULP$OOFRQGLWLRQ@5HVHWVRQO\WKH7ULPDOO
FRQGLWLRQV
 >7ULP&XUUHQWDQG*URXSFRQGLWLRQ@5HVHWV
RQO\WKHGDWDRI7ULPFRQGLWLRQLQXVHDQGDOO
WKHFRQGLWLRQVVHWWRJURXSPRGH
 >0RGHOPHQXVHWWLQJ@5HVHWVDOOWKHIXQFWLRQV
LQWKHPRGHOPHQXH[FHSWWKHFRQGLWLRQ
VHOHFWLRQIXQFWLRQV
 >$OOPRGHOVHWWLQJ@5HVHWVDOOWKHIXQFWLRQVLQ
WKHOLQNDJHPHQXDQGPRGHOPHQXH[FHSW
WKHIUHTXHQF\PRGHOVHOHFWDQGPRGHO
W\SHIXQFWLRQV
 >)XQFWLRQQDPH@5HVHWVRQO\WKHIXQFWLRQ
QDPHIXQFWLRQV
 >7HOHPHWU\@5HVHWVRQO\WKHWHUHPHWU\
IXQFWLRQV
([HFXWHUHVHWE\WDSSLQJWKH<HV
ŏ6HOHFW>'DWDUHVHW@DWWKHOLQNDJHPHQXDQGFDOO
WKHVHWXSVFUHHQVKRZQEHORZ
CAUTION
ThrottleReverse
■ Onlythethrottlechannel(CH3)initialsettingis
REV(reverse).ThoroughlychecktheHiandLow
directionsoftheengineormotorusedandbe
carefulthattheydonotsuddenlyrunatfull
speed.Evenafterdatareset,CH3isreversed.
CAUTION
NeverengagetheDataresetfunction
whiletheengineisstartingorthe
motordrivewiringisconnected.
■ Sudden,abruptspinningofpropellersorrotors
isextremelydangerous.
ŏ5HWXUQWR/LQNDJHPHQX