FUTABA 16SZ - Page 28

29
＜ BeforeUse ＞
Turnscrewclockwise.
Sticktensionmaximum
Sticktensionminimum
Turnscrewcounter-clockwise.
•Stick Tension (J2)
(Mode 2)
•Stick Tension (J1)
(Mode 1/2)
•Stick Tension (J4)
(Mode 1/2)
•Stick Tension (J3)
(Mode 1)
5. At the end of adjustment, re-install the side
cover and rear grips.
4.Use a screw driver to adjust the spring
strength as you prefer by turning the
adjusting screw of the stick you want to
adjust.
7XUQLQJWKHVFUHZFORFNZLVHLQFUHDVHVWKHWHQVLRQ
CAUTION: Loosening the screw too much
can interfere with the internal stick operation.
ŶŧŃŦƄƕƇŃŋƖƈƆƘƕƈŃƇƌƊƌƗƄƏŃƐƈƐƒƕƜŃƆƄƕƇŌŃŋƑƒƗŃƌƑƆƏƘƇƈƇŌ
The T16SZ transmitter model data can be stored by using any commonly found SD card. When
76=WUDQVPLWWHUXSGDWHVRIWZDUHLVUHOHDVHGWKHVRIWZDUHLVXSGDWHGXVLQJDQ6'FDUG7KH76=LV
capable of using SD and SDHC cards (SD:32MB-2GB SDHC:4GB-32GB).
ŶŧŃƆƄƕƇŃƕƈƄƇƈƕŒƚƕƌƗƈƕ
Saving model data and update files (released
from Futaba) into the SD card, you can use those
ILOHVRQ\RXU76=WUDQVPLWWHU(TXLSPHQWIRU
UHDGLQJDQGZULWLQJ6'FDUGVLVDYDLODEOHDWPRVW
electronics stores.
ŶƗƒƕƈƇŃƇƄƗƄ
When you have a problem of saving or reading
GDWDDIWHUDORQJSHULRGRIXVHSOHDVHJHWDQHZ6'
card.
*We are not responsible for, and offer no compensation for,
memory card data that fails or is damaged for any reason.
Be sure to keep a backup of all important data stored in your
SD card.