FUTABA 16SZ - Page 76

77
＜ Linkagemenu ＞
ŏ7DSWKH>)DLOVDIH@EXWWRQLQWKH/LQNDJHPHQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
Failsafe
6HWVWKHVHUYRVRSHUDWLQJSRVLWLRQZKHQWUDQVPLWWHUVLJQDOVFDQQR
ORQJHUEHUHFHLYHGRUZKHQWKHUHFHLYHUEDWWHU\YROWDJHGURSV
The Fail safe function is used to set up positions
that the servos will move to in the case of radio
LQWHUIHUHQFH'H¿QHVVHUYRSRVLWLRQZKHQVLJQDOVDUH
lost and when receiver battery voltage becomes low.
You may set either of two positions for each
FKDQQHO+ROGZKHUHWKHVHUYRPDLQWDLQVLWVODVW
commanded position, or fail safe, where each servo
moves to a predetermined position. You may choose
either mode for each channel.
7KH76=V\VWHPDOVRSURYLGHV\RXZLWK
an advanced battery monitoring function that
warns you when the receiver battery has only a
little power remaining. In this case, each servo is
PRYHGWRWKHGH¿QHGIDLOVDIHSRVLWLRQ7KHEDWWHU\
IDLOVDIHPD\EHUHOHDVHGE\RSHUDWLQJDSUHGH¿QHG
FRQWURORQWKHWUDQVPLWWHUGHIDXOWLVWKURWWOHDo
not continue to fly. Land as soon as possible.
Remember, if the predefined control suddenly
Fail safe setting procedure
Decide which channels you want to go to preset
positions, and which ones you want to maintain
their last commanded position. To select the fail
safe mode you wish to set, use the F/S button. This
EXWWRQWRJJOHVEHWZHHQWKHWZRPRGHV+ROG)6
F/S mode setting:
7DSWKH)6EXWWRQRIWKHFKDQQHO\RXZDQW
WRVHWDQGVHWWKDWFKDQQHOWRWKH>)6@
PRGH
+ROGWKHFRUUHVSRQGLQJVWLFNFRQWUROVOLGHU
RURWKHUFRQWUROLQWKHSRVLWLRQ\RXZDQWWKH
VHUYRWRPRYHWRZKHQWKHIDLOVDIHIXQFWLRQ
LVDFWLYDWHGDQGWDSWKH)6SRVLWLRQEXWWRQ
7KDWSRVLWLRQLVGLVSOD\HGLQSHUFHQWDJH
:KHQ\RXZDQWWRUHWXUQWKDWFKDQQHOWRWKH+ROGPRGHWDS
the [F/S] button again.
Battery fail safe setting procedure
7RVHOHFWWKH%)6PRGHWDSWKH>%)6@EXWWRQ
Each time the button is tapped, it toggles between
>2))@DQG>%)6@
moves to a position you did not command, land at
once and check your receiver battery.
'RQRWFRQWLQXHWRÀ\/DQGDVVRRQDVSRVVLEOH
Defines servo position when signals are lost and
when receiver battery voltage becomes low.
WARNING
Forsafety,alwayssetthefailsafefunctions.
■ Especiallysetthethrottlechannelfailsafefunction
sothattheservomovestothemaximumslowside
forairplanesandtotheslowsidefromthehovering
positionforhelicopters.Crashingofthemodelatfull
highwhennormalradiowavescannotbereceiveddue
tointerference,etc.,isverydangerous.
■ Iffailsafeisresetbythrottlestickmovement,thefail
safemaybemistakenasanenginemalfunctionand
willberesetatlowthrottleandthemodelwillcontinue
tofly.Ifyouhaveanydoubts,immediatelyland.
B.F/S setting:
7DSWKH>%)6@EXWWRQRIWKHGHVLUHGFKDQQHO
WRVHWLWWRWKH%)6PRGH
+ROGWKHFRUUHVSRQGLQJVWLFN95VOLGHU
RURWKHUFRQWUROLQWKHSRVLWLRQ\RXZDQW
WKHVHUYRWRPRYHWRZKHQWKHEDWWHU\IDLO
VDIHIXQFWLRQLVDFWLYDWHGDQGWDSWKH)6
SRVLWLRQEXWWRQ7KLVSRVLWLRQLVGLVSOD\HGLQ
SHUFHQWDJH
:KHQ\RXZDQWWRUHWXUQWKDWFKDQQHOWR2))WDSWKH>%)6@
button again.
Battery Fail safe release function
This function releases the predefined control
from its held position after indicating that your
receiver battery is low.
(QWHUWKHFRQWUROVHWWLQJVFUHHQE\WDSSLQJ
WKH%DWWHU\)6UHOHDVHEXWWRQ1RZ\RXPD\
FKRRVHZKHWKHUPRYLQJWKHWKURWWOHUHVHWV
WKHFRQGLWLRQRUVHOHFWDVWLFNRUVZLWFKWR
GHDFWLYDWHLW7RVHWDGHVLUHGWKURWWOHUHOHDVH
SRVLWLRQPRYHWKHWKURWWOHVWLFNWRWKHSRLQW
DWZKLFK\RXZLVKWKH%)6WREHUHOHDVHG
ŏ5HWXUQWR
/LQNDJHPHQX