81
Go to 3/7 from any
cursor position
(4)
AIL PIT: aileron collective pitch mixing rate
At the middle collective pitch, check that during right
to left and left to right aileron action the swash plate is
staying level on both the elevator and collective pitch
axis. If the swash plate is rising or falling with aileron
inputs, use the [
/+] or [ /-] key to raise or lower the
swash plate to match the middle point during aileron
inputs.
Setting ranges: 30 ~ 150% Initial value: 100%
(3) PIT ELE2: collective pitch 2nd elevator mixing rate
This parameter adjusts the pitch to 2nd elevator mixing rate. The rates
can both be adjusted individually for both full high and low collective posi-
tions. Note: This setting is only available if the H4-xx swash mode has
been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
(5) AIL ELE: aileron elevator mixing rate
This parameter adjusts the aileron to elevator mixing rate. The rate can
be adjusted for left and right directions individually. Note: This setting is
only available if the H4-45 swash mode has been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
(6) AIL ELE2: aileron 2nd elevator mixing rate
This parameter adjusts the aileron to 2nd elevator mixing rate. The rate
can be adjusted for left and right directions individually. Note: This setting
is only available if the H4-45 swash mode has been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
SWH. DETAIL screen 2/7
From 1/7
To Next Page
Loading...
