82
SWH. DETAIL screen 3/7
From 2/7
Go to 4/7 from any cursor position
(7) ELE PIT: elevator collective pitch mixing rate
During back and forward elevator inputs at middle collective, check if the
swash plate is raising or lowering during the input. If it is moving use the [
/+] or [ /-] key to raise or lower the swash plate to match the middle point
during elevator inputs. Note: This setting can not be used when H4-00
swash mode is selected.
Setting ranges: 30 ~ 150% Initial value: H3-120 = 50%, except H3-120 = 100%
(8) ELE AIL: elevator aileron mixing rate
While moving the elevator back and forth at middle collective, check to make
sure the aileron axis is staying level. Use the [
/+] or [ /-] key to raise or
lower to level the swash plate so that it remains level during full forward and
back elevator input. Note: This setting can not be used when H4-00 swash
mode is selected.
Setting ranges: 30 ~ 150% Initial value: H3-120 = 50%, except H3-120 = 100%
(9) ELE ELE2: elevator 2nd elevator mixing rate
This parameter adjusts the elevator to 2nd elevator mixing rate.
The rate can be adjusted separately for up and down directions
individually.
Note: This setting is only available if the H4-xx swash
mode has been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
To Next Page
Loading...
