FUTABA GPB-1 - Page 13

13
Config
Config
5HVHWHDFK&RQ¿JLWHP,WUHWXUQVWRWKHLQLWLDOYDOXH
Config 6/7 HoldingPower
Config 7/7 Reset
Keyoperation →
Howtooperateeachmenuscreen
Howtooperateeachmenuscreen
1.
Use the [
/+] or [ /-] key to move the cursor to the [RE-
SET] on the screen and press the [Enter] key to enter the
setting mode.
2.
As shown on the left screen, [EXECUTE: "Enter" (1sec)]
is displayed.
3.
Press and hold the [Enter] key to reset.
C1 C5
-100% 100%-35% 35%0%
C1 C3
C5C4C2
-100% 100%-25%-75% 75%25%0%
-100%
100%
0%
C1
C5
Displayofholdingpowerrate
Withtheswitchbutton,the"holding
power"ofeachrate(C1toC5)canbe
displayedandadjusted.
The current rate numbers C1 to C5 are displayed by operating the channel of the transmitter.
/LNH WKH ÀLJKW FRQGLWLRQ IXQFWLRQ RI WKH WUDQVPLWWHU\RXFDQVHW XS WR  GL൵HUHQW GDWD IRU WKH DWWLWXGH
KROGLQJIRUFHUDWHRIWKHDLUFUDIWLQ$9&6PRGHE\RSHUDWLQJWKHVZLWFKIURPWKHWUDQVPLWWHUDQGVZLWFK
between them. You can set the holding power rate selector switch to the channel with the AFR function of
the transmitter, and set the point for each rate on the AFR point curve to switch. It is also possible to use
WKHÀLJKWFRQGLWLRQIXQFWLRQWRZRUNZLWKWKHÀLJKWFRQGLWLRQVZLWFK
When set to SW of DG1 or DG2
Switch channel rate
Channel rate
When set to dial or lever
S.BUSBasic2/3
Displayandadjustthecurrentrate
numbersC1toC5byoperatingthe
channelonthetransmitter.
,WLVDIXQFWLRQWRDGMXVWWKHSRVWXUHKROGLQJIRUFHRIWKHDLUFUDIWLQ$9&6PRGH
Decreasing the value weakens the holding power and makes the operation feeling closer to the normal
mode.