CONTROL BOX INSTALLATION
6
Using wire mounts, wiring fi xtures molded into
the helicopter, or hook and loop material, route the
extensions to the receiver. Ensure that the extensions
leading to the receiver cannot become entangled in
rotating components and make sure the extensions
are not rubbing against metal or carbon fi ber which
may damage the wires. Once the power system is
installed and connected, please move onto the next
step to learn how to program the gyro.
GY701 BASIC SETUP
Turn your transmitter on and allow it to initialize.
Switch the helicopter on and allow the GY701 to
initialize. During the initialization of the gyro, the
screen will show an animated helicopter. Once the
screen changes to show status, the initialization
is complete.
To Next Page
Loading...
