8
L
H
V
Tilt measurement
The tilt-sensor is activated activate by default when the device is switched on. You can
activate or deactivate the function by pushing . The number of degrees of the slope
are shown at the top of the screen.
Inderect measurement
The instrument can calculate distances using Pythagoras’ theorem.
Make sure you adhere to the prescribed sequence of measurement:
All target points must be in a horizontal or vertical plane.
(e.g. with the position bracket fully folded out and the instrument placed on a wall).
The minimum/maximum measurement can be used. The minimum value must be
used or measurements at right angles to the target; the maximum distance for all
the other measurements.
-
gles. Use the minimum/maximum function, as explained in “Measuring ª Minimum/
maximum measurement”.
To Next Page
Loading...
Need help?
General
