Futek IHH500 - User Manual

Quick Start Guide
Sensor Solutions Source
Load · Torque · Pressure · Multi Component · Calibration · Instruments · Software
www.futek.com
IHH500
Intelligent Handheld Display

Summary

Display Features

Display Connectors

Connectors for power, USB, output, and sensor interfaces.

Display Information

Information displayed on the LCD, including channel, values, and sampling rate.

Display Controls

Buttons and features for resetting, calibration, and power.

Display Options

Options for adjusting display font size and appearance.

Buttons

Menu Navigation Buttons

Buttons used for menu navigation, unit selection, display changes, and tare functions.

Special Function Buttons

Buttons for battery status, shunting, track/hold, and power.

Connector Pin Configuration

Power Connector Pinout

Pinout diagram for the Power connector.

USB Connector Pinout

Pinout diagram for the USB connector.

Output Connector Pinout

Pinout diagram for the Output connector.

Sensor Connector Pinout

Pinout diagram for the Sensor connector.

Wiring Layout

Power Connections Wiring

Wiring details for the Power connections.

Output Connections Wiring

Wiring details for the Output connections.

USB Port Connections Wiring

Wiring details for the USB Port connections.

Sensor Wiring

Sensor Connections Wiring

Wiring details for Sensor connections.

12-Pin Sensor Binder Assembly

Information regarding the 12-pin sensor binder assembly.

Profile Quick Setup

Profile Lockout and LCD Settings

Analog Output Quick Setup

Alarm and Relay Quick Setup

Troubleshooting Tips

Futek IHH500 Specifications

General

Material	17-4 PH Stainless Steel
IP Rating	IP67
Capacity	500 lb
Output	2 mV/V (Nominal)
Power Supply	10 VDC
Accuracy	±0.5% of RO
Nonlinearity	± 0.5% of RO
Hysteresis	± 0.5% of RO
Nonrepeatability	±0.5% full scale
Repeatability	±0.5% full scale
Safe Overload	150% full scale
Ultimate Overload	300% of Capacity
Bridge Resistance	350 Ohm
Excitation Voltage	10 VDC to 15 VDC
Cable Length	10 ft