Future light PHS-250 Pro-Head-Spot - Page 35

35
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
rDis
- Reverse the display 180°
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “rDIS” by pressing [UP] button;
3. Press [ENTER], the display shows “ON” or “OFF”;
4. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t;
5. Press [ENTER] to confirm
6. Press [EXIT/DN] to return to main menu, the display will change 180°
rpan
- Pan reverse movement
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “rPAN” by pressing [UP] button;
3. Press [ENTER], the display shows “ON” or “OFF”;
4. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t;
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
rtil
- Tilt reverse movement
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “rTIL” by pressing [UP] button;
3. Press [ENTER], the display shows “ON” or “OFF”;
4. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t;
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
Rest
- Reset
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “rEST” by pressing [UP] button;
3. Press [ENTER], the display shows “ON” or “OFF”;
4. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t;
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
Inda
- Reload the data into the EEPROM and restore the factory settings
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “INDA” by pressing [UP] button;
3. Press [ENTER], the display shows “ON” or “OFF”;
4. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t;
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
Lamp
- Switch on/off the lamp
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “LANP” by pressing [up] button;
3. Press [ENTER], the display shows “ON” or “OFF”;
4. Press [UP] to select “ON” if you wish to switch on the lamp or “OFF” if you wish to switch off the lamp;
5. Press [ENTER] to confirm
6. Press the Exit/Down-button in order to return to the main menu..
Ver
- Software version
1. Press [ENTER] for 3 seconds to enter main menu;
2. Select “UER” by pressing [UP] button;
3. Press [ENTER], the display shows “U-X.X”, “X.X “ stands for the version no. such as the display may
show “U-1.0”. “U-2.6” etc;
4. Press [ENTER] or [EXIT/DN] to exit.