Original User Manual FUXTEC CTL-900 – rev1
_________________________________________________________________________________
14
3.10 Maintenance and care
The product should be checked and cleaned regularly.
– Please regularly check all essential parts for damage. Make sure that the mechanical
components are working correctly.
– Please regularly check that all screws, rivets, bolts and other fastenings are tight.
– Do not use grease or oil for lubrication, but a silicone-based spray.
– Too heavy a load, improper folding or the use of unauthorised accessories can damage or
destroy the wagon.
– Never load more than 5 kg into the rear bag.
– Store the folded wagon only in a well-ventilated place to prevent mould growth.
– The textile parts may lose colour if exposed to heavy use over an extended period (e.g.
intensive sunlight); however, this does not constitute a reason for complaint.
– Do not use the wagon if parts are bent, worn or broken.
– Do not use accessories that have not been approved by FUXTEC GmbH for use with the CTL
900.
Loosen all velcro fasteners and press
buttons at the front and back of the
wagon.
Open all velcro fasteners on the
underside of the wagon. Afterwards,
you can remove the loose fabric
cover from the frame.
To Next Page
Loading...
Need help?
General
