FUXTEC FX-BV140 - Page 14

Original User Manual FUXTEC FX-BV140 rev03
14
5.1 TO START THE ENGINE
1. Before you start the engine, please turn the engine switch to "ON." (Fig.7A)
3. To start a cold engine, set the throttle stick to "On" (Fig. 7B). Move the throttle lever to the "Off" position.
(Fig.7B).
4. Stand behind the device, grasp the brake lever, and hold it against the lower handle.
(Fig.7C)
5. Hold the brake lever as shown in Fig.7C and quickly pull up the starter handle, as shown in Fig.7D. After
starting the engine, slowly return it to the cable guide pins.
6. Set the throttle lever to the "On" position. (Fig.7F)
NOTE! If the cutting unit comes into contact with the ground, the device may move jerkily.
Fig.7A Fig.7B Fig.7C
Throttle lever
Fig.7D Fig.7E
Carburetor lever
Grasp the brake
lever.