FUXTEC FX-BV140 User Manual

Original User Manual FUXTEC FX-BV140 rev03
21
12.
TROUBLESHOOTING AND REPAIR
Problem
Possible reasons
Corrective actions
The engine does not start The throttle valve is not in the
correct position.
Move the throttle valve to the
correct position.
The fuel tank is empty. Fill the tank with fuel: see
MANUAL.
The air filter element is dirty. Clean the air filter element: see
MANUAL.
The spark plug is loose. Tighten the spark plug.
The spark plug lead is loose or
disconnected from the plug.
Fit the spark plug cable to the spark
plug.
The gap does not correspond to
the spark plug.
Adjust the correct gap between the
electrodes.
The spark plug is defective. Fit new, correctly closed plug: see
MANUAL.
The carburetor is running full of
fuel.
Remove the air filter element and
pull continuously on the starter
cable until the carburetor has freed
itself and then install the air filter
element.
Defective ignition module. Contact customer service.
Engine speed is reduced. The cutting depth is too large Set to the smaller cutting depth
The grass too high Mow the lawn before loosening.
The discharge opening is blocked Pull out the spark plug connector
and remove the blockage.
The air filter is clogged Clean air filter: see MANUAL.
Poor results when mowing The cutting depth is too small Adjust to more considerable cutting
depth.
Worn cutting blades Exchange of the cutting blades in a
special workshop.
The grass collector never fills up. The grass collector is full/clogged. Stop the scarifier. Empty or clean
the grass collector
The ejection chute is blocked Pull out spark plug connector, clean
ejector shaft
Unusual noises Screws, nuts, or other fastening
parts are loose.
Tighten the parts.
Vibration
The cutting device is loose. Tighten the blade firmly.
The cutting device is not in
balance.
Balance the blade.

FUXTEC FX-BV140 Specifications

General

Brand	FUXTEC
Model	FX-BV140
Category	Lawn and Garden Equipment
Language	English