Original Bedienungsanleitung FUXTEC FX-FSR152_de_en_fr_ita_rev06
45
29. Cold start of the device
WARNING
The cutting head rotates immediately when the engine is started.
1) Ensure a secure stand and a firm and level surface.
Slide the engine stop switch on the right handle to the position I
Push the switch to position 0 you have no ignition spark and the engine cannot be started
2) Move the choke lever upwards to "COLD START".
3) Press the carburettor pump about 8-10 times (until gasoline flows in the line)
4) Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous fast train will provide a vital spark and start the engine
5) Then set the choke lever to the "WARM START" position
6) Let the engine warm-up for a few minutes at idle
To Next Page
Loading...
