Original User Manual FUXTEC FX-GS36S
4
1. Intended use
The spreader is to be used exclusively for spreading granules.
If your spreader does not distribute the granules evenly, make sure that the front of the
gearbox points to the front of the spreader. The impeller must turn clockwise. Reversing the
gear will cause the impeller to rotate counterclockwise. Clean the paddlewheel after each
use, residues on the bucket wheel cause uneven distribution.
Your spreader is designed to give the best spreading results when pushed at 5 km/h (fast
walking). Slower or faster speeds will change your spreading pattern. Moist grit or granulate
changes the flow velocity and spreading pattern. Clean your spreader thoroughly after each
use. Gears are already lubricated at the factory.
2. Preparation and security
• Wear face protection or safety goggles during use
Wear appropriate clothing. Only wear closed shoes with non-slip soles. Use of the
granulate spreader with sandals or barefoot is prohibited
• Wear close-fitting clothing. Avoid too loose clothing
• Wear non-slip gloves during use
If necessary, wear a dust mask, starting from the material to be scattered
• Long hair should be bound back
• Apply directional markings before using the granulate spreader
• Use only in daylight or good artificial light
• Read and follow all instructions of the chemical manufacturer
ATTENTION
During work, the line of sight must be directed to the surface to be processed; do not
be distracted
• Ensure a secure stand and direction of movement. Caution on unpaved or slippery
surfaces
• Attention: Chemicals or materials that are hazardous to the environment should be
avoided
Follow all guidelines of the chemical manufacturer
To Next Page
Loading...
General