FUXTEC FX-IG13 - Troubleshooting

Original Bedienungsanleitung FUXTEC FX-IG13_de_en_fr_ita_rev04
32
17 TROUBLE SHOOTING
Trouble
Possible cause
Solution
Engine does not start
• Incorrect starting sequence
• Observe the correct starting
sequence
• Dirty air cleaner
• Clean/replace air cleaner
• No fuel supply
• Refuel
• Fault in the fuel line
• Check the fuel line for kinks
or damages
• Engine flooded.
• Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
• Spark plug connector not placed on.
• Place on the spark plug
connector
• No ignition spark
• Clean/replace spark plug
• Check ignition cable
• Fuel cock closed
• Open fuel cock
• Engine oil to few
• Check engine oil
Engine starts and is stalled
immediately
• Incorrect idle adjustment
• Contact customer service
Machine works with
interruptions
• Carburetor incorrectly adjusted
• Contact customer service
• Spark plug fouled
• Clean/replace spark plug
• Check spark plug connector
Low oil light glows
• Check oil level
• Fill engine oil
Low oil light glows
• To less or no oil
• Fill engine oil
Overload indicator light glows
• Low voltage protection activated
• Engine speed to low
Overload indicator light glows
• High temperature protection
activated
• Cool down the engine
Overload indicator light glows
• Overload protection activated
• To big loads
Overload indicator light glows
• Short circuit protection activated
• Check loads
N O T I C E
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.