10. EXHAUST PORT
a. Remove the muffler and use a screwdriver to remove carbon
deposits from the exhaust port. Also remove carbon deposits from the
exhaust port and cylinder exhaust port. (F13)
(1) Screwdriver
(2) Exhaust silencer
b. Retighten screws, bolts and brackets.
c. Check that no oil or grease has come between the clutch lining and the clutch drum and
clean with oil and lead-free petrol if necessary.
11. TIGHTENING
When attaching the blade, make sure to secure the spacer, washer and
screw, then tighten the nut.
(1) Screw
(2) Washer
(3) Spacer
(4) Nut
- Check the blade and fasteners for tightness, cracks or bending.
- Check the cutting edges and sharpen with a flat file.
- Keep the cutting edges sharp.
- Round off the back.
- Do not grind with water.
The distance between the upper and lower shearing blades does not
need to be adjusted, as this product, due to its design, always
guarantees an optimal distance when assembled correctly. (F11)
To Next Page
Loading...
