What to do if the FUXTEC FX-PS152 Trimmer engine does not reach the moving elements?
If the FUXTEC Trimmer engine isn't reaching the moving elements, it might be because the choke is in the 'COLD START' position, or the exhaust system is blocked. To resolve this, open the choke and replace the exhaust system.
Why is my FUXTEC FX-PS152 leaking?
If your FUXTEC Trimmer is leaking, it could be due to a failure of the check valve on the tank cap or a worn-out carburetor gasket. Try replacing the fuel filler cap first. If the problem persists, replace the carburetor or gasket.
How to fix no ignition of the FUXTEC FX-PS152 Trimmer spark plug?
If the FUXTEC Trimmer spark plug isn't igniting, it could be due to carbon deposits between the diodes, a defective ignition coil, or a weak flywheel. Try cleaning the spark plug first. If that doesn't work, replace the ignition coil or flywheel.
Why does my FUXTEC Trimmer have weak ignition?
If the FUXTEC Trimmer has weak ignition, it could be caused by worn piston rings, a spark plug that isn't screwed down tightly, a cylinder head that isn't tight, or incorrect valve clearance or ignition timing. Replace or adjust these components as needed.
General| Type | String trimmer |
|---|---|
| Head type | Nylon line |
| Handle type | U-type handle |
| Engine power | 3 hp |
| Product color | Black, Orange |
| Rotational speed | 7100 RPM |
| Number of strokes | 2 |
| Fuel tank capacity | 1.2 L |
| Vibration emission | 9.661 m/s² |
| Automatic line feed | Yes |
| Engine displacement | 52 cm³ |
| Sound pressure level | 99.5 dB |
| Cutting diameter (max) | 440 mm |
| Sound power level guaranteed | 113 dB |
| Sound power level uncertainty | 3 dB |
| Power source | Gasoline |
Weight and Dimensions| Weight | 7500 g |
|---|
Understand manual, heed warnings, and follow general safety guidelines.
Wear appropriate eye, ear, head, foot protection, and gloves.
Device is for mowing and trimming grass, weeds, and undergrowth only.
Use sharp blades, check for obstacles, avoid cutting trees.
Identifies all parts of the brush cutter/grass trimmer.
Instructions for fitting the handle to the device.
Steps to connect the drive axle to the main shaft.
Secure the device properly during transport to prevent damage or injury.
Addresses issues encountered when starting up the device.
Lists the EN standards applied for compliance.
To Next Page
