FUXTEC FX-PS152 User Manual

Original User Manual FUXTEC FX-PS152 / FX-PS162
24
15. Storage of the device
WARNING: Failure to follow these steps may result in the formation of
deposits in the carburetor. This will make starting difficult and cause
permanent damage
1. Perform all general maintenance as described in the maintenance section of your
user manual are recommended.
2. Clean the exterior of the device, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After draining fuel, start the engine.
5. Let the device run in neutral until the device stops on its own. This will clean the
carburetor of fuel.
6. Let the device cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter cord
slowly several times to coat internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil burner,
water heater, etc.
TRANSPORT PROTECTION
Make sure that the device is well-secured during transport to avoid fuel loss, damage, or
injury. Install transport protection for metal sheets during transport and storage

FUXTEC FX-PS152 Specifications

General

Type	String trimmer
Head type	Nylon line
Handle type	U-type handle
Engine power	3 hp
Product color	Black, Orange
Rotational speed	7100 RPM
Number of strokes	2
Fuel tank capacity	1.2 L
Vibration emission	9.661 m/s²
Automatic line feed	Yes
Engine displacement	52 cm³
Sound pressure level	99.5 dB
Cutting diameter (max)	440 mm
Sound power level guaranteed	113 dB
Sound power level uncertainty	3 dB
Power source	Gasoline

Weight and Dimensions

Weight	7500 g