What to do if my FUXTEC Trimmer carburetor is leaking?
If the carburetor of your FUXTEC Trimmer is leaking, it could be due to a failure of the check valve on the tank cap or because the carburetor gasket is worn out. Try replacing the fuel filler cap or replacing the carburetor or gasket to resolve this issue.
Why are operating materials leaking from my FUXTEC FX-MS125?
If operating materials are leaking from your FUXTEC Trimmer, it could be due to blocked lines to the carburetor or an incorrect spark plug spacing. Try replacing the lines and carburetor or adjust the gap dimension.
Why the engine of my FUXTEC FX-MS125 Trimmer does not reach the speed?
If the engine of your FUXTEC Trimmer does not reach full speed, it might be because the choke is in the 'COLD START' position, the exhaust system is blocked, there's no air supply, moving elements are worn, the ignition spark is weak, the valve clearance is too large, or the cylinder head is sooty. Try opening the choke, replacing the exhaust system, checking or replacing the ignition coil, adjusting the flywheel, and replacing the spark plug.
Why FUXTEC FX-MS125 Trimmer has weak ignition spark?
If your FUXTEC Trimmer has a weak ignition spark, it could be due to too much petrol in the combustion chamber, lousy fuel, water in the tank, a blocked oil line, worn piston rings, a loose spark plug, a loose cylinder head, wrong valve clearance or ignition timing, or poor contact between the ignition cap and spark plug. You should remove the spark plug and allow it to dry, and replace the fuel. Also try cleaning the carburetor and the pipes, replacing or tightening the screw, and checking or replacing the ignition cap.
How to fix no ignition spark in FUXTEC FX-MS125 Trimmer?
If your FUXTEC Trimmer has no ignition spark, it could be due to carbon deposit between the diodes of the spark plug or a defective ignition coil or a weak flywheel magnet. You should clean the spark plug and adjust the gap to 0.6~0.7mm, or replace the spark plug. Also, consider replacing the ignition coil or flywheel.
Details the procedure for correctly installing the metal cutting blade.
Outlines the process for attaching the nylon thread spool for grass trimming.
Details the precise fuel and oil mixing ratios for optimal engine performance.
Specifies the recommended grade of unleaded petrol for use with the device.
Instructions for cleaning the air filter to ensure optimal engine performance.
Details the procedure for checking, cleaning, and adjusting the spark plug.
Provides instructions on how to properly sharpen the device's cutting blade.
Addresses specific problems that may arise while the device is in use.
To Next Page
General
