FUXTEC FX-MHP126 - Storage Preparation and Long-Term Maintenance

Standard Operating Manual FUXTEC FX-MHP126_rev03
22
System/Component
Procedure
before use
Every 25
hours
after
Every 50
hours
after
Every
100
hours
after
NOTE
ENGINE
Fuel leaks, Fuel splashes
wipe
X
Replace if
necessary
Fuel tank, air filter, fuel filter
check/clean
X
X
Replace
carburettor, if
necessary
Adjusting screw for idling
Check setting
Idling
X
GAP: 0.6 - 0.7mm
Replace if
necessary
spark plug
Clean and readjust
cylinder gap
X
Cylinder fins, air intake
opening
clean
X
muffler, spark extinguisher,
cylinder outlet
clean
X
SHAFT
throttle valve lever, ignition
switch
Check function
X
cutting parts
replace if
something is not
correct
X
Gearbox housing
Lubricate
X
Screws/nuts/bolts
tighten/change
X
X
not the adjusting
screws
MAINTENANCE BEFORE LONG-TERM STORAGE
IMPORTANT!
When draining the fuel, avoid spilling the fuel. Spillage must be removed and the lid of the
container closed tightly.
1. Have the engine run with an empty fuel tank until it stops on its own to remove any
remaining fuel in the engine.
2. Remove the spark plugs and pour 1-2cc of two-stroke engine oil into the engine. Pull the pull
starter 2 - 3 times. Then reinstall the spark plugs.
3. Wet metal parts with anti-rust oil and place the protective cover on the cutter.
4. store the device in a place protected from moisture.