21
4.
Preparation before Use
4.1Piling Socket
4.1.1 Install or change piling socket retainer. Select a corresponding retainer according to the sizes of the piling from 20-
45 or 46-80, as it’s shown in Fig.3., such as
4.2 Fuel
Use 90# gasoline and two-stroke special engine oil or above
Recommended mixing ratio
Condition Gasoline: engine oil
Operation within 20 hours 20:1
Operation of over 20 hours 25:1
4.2.1 Pure gasoline (without two-stroke engine oil) is forbidden as fuel.
4.2.2 Add fuel in a well-ventilated place.
4.2.3 Do not add too much oil. The oil shall not exceed the neck of oil can. If fuel spills, wait until the fuel volatilizes
completely and then start the machine.
4.2.4 After refueling, tighten the lid of Oil can.
5.
Starting
5.1. Before starting the new machine, press the transparent and semi-circle fuel bubble repeatedly (Fig.4) until carburetor
is filled with fuel. (If the engine is cool, close the air door. Open air door after starting.)
Fig 3
To Next Page
Loading...