FWC DWM-IV - Standard Features; Keyboard and Pushbutton Functions; Data Handling Features

Standard Features:
Keyboard programmable setup: All select functions, setup and calibration are
programmable through the keyboard. Access to setup mode is enabled by internal switch.
Pushbutton Zero: Used for establishing gross zero.
Pushbutton Tare: Automatically tares the weight of object placed on the scale and
places scale in the net mode.
Auto Zero Tracking: Automatically tracks zero (0) within 1/4 digit to ensure a stable
zero (0) over time.
Gross/Net Pushbutton: View net and gross weight when tare weight has been entered.
Print Pushbutton: Transmits data out of serial port.
Numeric ID: Single register to enter up to seven (7) digits of numeric identification.
CN: Six (6) digit consecutive number increments each time the [PRINT] button is
pressed.
Recall Tare Pushbutton: Used for recall viewing of tare weights.
Keyboard Tare Pushbutton: 10 Tare look-up (09) to enter predetermined tare values.
PC WT Entry: 9 piece weight look-up (19) determines count by entering pre-
determined piece weight.
Weight Accumulation: 10 weight accumulation registers with subtotal.
Digital Filter: Compensates for vibration or motion, keyboard selected from 1 to 32
updates per average.