17
• Low outside temperatures
• Extended periods of use We therefore recommend you wear warm work gloves and
take regular breaks.
7. Before first use
Times of use Please comply with statutory regulations, which may vary from location
to location. Make sure that you are familiar with the controls and operation of the
machine. In particular, the user must know how the work tools and engine can be
stopped quickly. The machine must only be used by persons who have read the
instruction manual and are familiar with operation of the machine. The user should
seek expert and practical instruction prior to initial operation. The user must receive
instruction on safe use of the machine from the vendor or another expert.
During this instruction, the user should be made aware.
• that the utmost care and concentration are required for working with the machine.
• that a ride-on mower which is sliding down a slope cannot be brought under control
by applying the brake.
The main causes for the loss of control over the ride-on mower include:
• inadequate adhesion of the wheels,
• driving too fast,
• inappropriate braking,
• incorrect use (sport events, etc.),
• inadequate knowledge of the effects associated with ground conditions, especially on
slopes (see section „Workplace safety “, „Working on slopes “),
• incorrect attachment of loads and poor load distribution.
Check the fuel system (particularly visible parts such as: tank, tank cap, hose
connections) before operating the machine. In the event of any leaks or damage, do
not start the engine – firhazard! Have the machine repaired by a specialist dealer prior
to operation.
Defective and all other worn or damaged parts must be removed before using the
machine. Replace any illegible or damaged danger signs and warnings on the machine.
The screwed-on discharge port (discharge chute on mowing deck) must always be
securely fastened to the mowing deck. It must not be damaged and, if necessary, it
must be replaced by a technician.
The braking function must be checked before each use.
Before each use, check whether:
• the cutting tool and the entire cutting unit (mowing blade, blade clutch, blade brake,
retaining pin, mowing deck housing) are in good condition. Particularly check for
secure fastening, damage and wear.
• the tank cap is securely attached.
• the tank and fuel-carrying parts, as well as the tank cap are in good condition.
• the safety devices are in good condition and function correctly.
• the tyres (inflation pressure, damage, wear) and frame are in good condition. Check
that all screw connections are securely fastened. In particular, all maintenance
To Next Page
Loading...
